Welcome Guest: Login | It is currently Thu Oct 19, 2017 11:04 am

Board index Development & Design Boat Construction Thwart Position

Moderator: Sabre


Thwart Position

Postby andrewb on Tue Mar 04, 2008 10:55 pm

I'm replacing the thwart. What is the position on the thwart (i.e. transom to thwart distance)?

The old thwart overhung the back of the support at the rear of the centreboard case & there was a small piece of timbe connected to the front edge of the thwart that covered the front edge of the back of the centreboard case. If it can be moved about 15mm forward from where it was then the thwart won't overhanng at the back & will cover the back of the centreboard case.

Does the traveller rope have to be tied off at the thwart or can it pass through the thwart & be made off on the floor at the base of the centreboard case?
andrewb
 
Posts: 35
Joined: Tue Jan 31, 2006 11:04 pm

Postby Mike Simpson on Mon Mar 10, 2008 9:30 pm

Andrew

No one appears to have picked up your request so I'll give it a go.

The thwart is positioned with its front edge at the rear of the centrecase slot.

The "small piece of timber" you mention is the thwart strengthener and is a required part of the boat - I recommend you construct it of 19mm plywood.

The mainsheet hawse must be of cord and anchored with a knot on one of the holes in the thwart and led thru' the other side and back to a cleat (My boat has a clam cleat C11 Mk2 set on top of a mounting block fixed to the thwart strengthener) for ready adjustment on the water.

Be careful to get the holes for the mainsheet hawse within tolerance - between 500 & 510 mm apart centre to centre - keep them as small as possible to avoid reducing the strength of the thwart.

Mike Simpson
Mike Simpson
 
Posts: 80
Joined: Thu Apr 28, 2005 9:51 am
Location: Melbourne


Return to Boat Construction

Who is online

Users browsing this forum: No registered users and 1 guest

cron