Welcome Guest: Login | It is currently Tue Oct 24, 2017 10:25 pm

Board index Development & Design Rigs & Sails What Halyard, Sheet and Control line sizes are being used?

Moderator: Sabre


What Halyard, Sheet and Control line sizes are being used?

Postby Chriso on Mon Jan 15, 2007 1:22 pm

If you were going to redo your Halyard, Sheets and Control lines what sizes and construction would you use? It has been suggested I could use:

4mm Vectran Halyard
8mm Mainsheet
4mm Daynema control lines.

Are there any thoughts on this? Is it too underspec?
Chriso
 
Posts: 19
Joined: Thu Jan 11, 2007 4:22 pm
Location: Bayside - Victoria

Postby Mike Simpson on Mon Jan 15, 2007 1:49 pm

These sizes are plenty strong enough and I would only increase them for comfort. If you do increase the size of any, ensure the size chosen will fit the pulleys and cleats in the system. Drag in the system can result in some embarrassing moments.

Don't go below 4mm for the halyard if you are not using wire with a rope tail, as there is always a little stretch in the rope regardless of what the manufacturer claims. This will settle to a minimum after the first few uses.

I don't believe it necessary to use ultra low-stretch cordage for vang, outhaul and downhaul and you can save a few dollars by buying conventional polyester ropes for these purposes.
Mike Simpson
 
Posts: 80
Joined: Thu Apr 28, 2005 9:51 am
Location: Melbourne


Return to Rigs & Sails

Who is online

Users browsing this forum: No registered users and 1 guest